The driver's seat

Something for the driver to play with

For the first project hours I had built components and attached them here and there, with an obvious bottom-up principle, without any specific plan or concentration on a specific area within the battle compartment. Now the beast started being in a state where some subareas were to be worked on.

Controllers

Until now the poor driver had only received a single stick, that maybe had something to do with setting the gears or not. Now the dude received some more crap to fill up his working environment.

The first photoetch piece of the kit ended up living next to the driver's head, to the left front edge. At this point the function of this setup was half a mystery. It looked like a periscope, and most likely was one.

A friend of mine in IRC referred to the plate below as a "nail plate" in Finnish, so the translation may be off a bit or eight. Whoever it was, it was installed below some pedals. I still had no idea of how a tank was driven, so I assumed them being a brake and a clutch, while the acceleration (or separately braking the left/right track) was done via the handles.

With the controllers installed and no explanation given about anything the place looked like a jungle. To my eyes the pedals looked like they were a bit too high up compared to the floor level.

Ohjaimet asennettuna, kahvojen merkitystä ei missään selitetty ja polkimet näyttivät olevan vähän hämmentävän korkealla tämänhetkiseen lattiatasoon nähden.

The freshly installed nail plate (?) at least protected the driver's feet from the torsion bars, but the ergonomy really made me suspicious, especially with the pedals being so far away from this new foot-resting plate. Then again, my only experience of sitting inside a tank is from a T-55M, that had pedals like from a go-kart than anything that we've seen here. So I had no real clue for comparison.

Meanwhile, further back

At this point I also built the firewall between the combat compartment and the engine compartment, with the pipes and whatnots. This piece of wall sat into its slot pretty damn nicely.

The driving seat

This seat was built out of quite a load of pieces. Especially while fiddling with the small, unglued axles the bench seemed like it could maybe be adjusted inside the model. Somehow.

Despite the freehand gluing position the bench complex settled in pretty nicely and, surprisingly, sturdy-lookingly.

Sadly I didn't have any sitting 1:35 scale gentlebeings readily available, in a sitting position or otherwise. At this point the bench looked functional. I was just wondering, how did it work in the real world when the dude wanted to actually see where he was driving and popped his cabbage out of the hatch? I somehow doubted it was as convenient as an office chair with quick-locks and whatnot.